Changing the Engine Oil and Oil Filter

You must change the engine oil and oil filter regularly in order to maintain the engine's lubrication. The engine may be damaged if they are not changed regularly.

Change the oil and filter in accordance with the maintenance message on the information display*/multi-information display.

1. Run the engine until it reaches normal


1. Run the engine until it reaches normal operating temperature, and then turn the engine off.

2. Open the hood and remove the engine oil fill cap.

1.8 ℓ engine models

3. Remove the bolts on the undercarriage and remove the under cover.

NOTICE


You may damage the environment if you do not dispose of the oil in a suitable way. If you are changing the oil by yourself, appropriately dispose of the used oil. Put the oil in a sealed container and take it to a recycling center. Do not throw the oil away into a garbage can or onto the ground.

All models


All models

4. Remove the drain bolt and washer from the bottom of the engine, and drain the oil into a suitable container.

5. Remove the oil filter and dispose of the


5. Remove the oil filter and dispose of the remaining oil.

6. Check that the filter gasket is not stuck to the engine contact surface.

If it is stuck, you must detach it.

7. Wipe away dirt and dust adhering to the contact surface of the engine block, and install a new oil filter.

Apply a light coat of new engine oil to the oil filter rubber seal.

8. Put a new washer on the drain bolt, then reinstall the drain bolt.

Tightening torque:

1.8 ℓ engine models

29 lbf∙ft (39 N∙m, 4.0 kgf∙m)

2.4 ℓ engine models

30 lbf∙ft (40 N∙m, 4.0 kgf∙m)

9. Pour the recommended engine oil into the engine.

Engine oil change capacity (including filter):

1.8 ℓ engine models

3.9 US qt (3.7 L)

2.4 ℓ engine models

4.4 US qt (4.2 L)

10.Reinstall the engine oil fill cap securely and start the engine.

11.Run the engine for a few minutes, and then check that there is no leak from the drain bolt or oil filter.

12.Stop the engine, wait for three minutes, and then check the oil level on the dipstick.

If necessary, add more engine oil.

You will need a special wrench to replace the oil filter. You can buy this wrench from a dealer.

When installing the new oil filter, follow the instructions supplied with the oil filter.

Reinstall the engine oil fill cap. Start the engine. The low oil pressure indicator should go off within five seconds. If it does not, turn off the engine, and check your work.

    See also:

    Starting the Engine
    1. Make sure the parking brake is applied. Automatic transmission models 2. Check that the shift lever is in , then depress the brake pedal. Although it is possible to start the vehicle in ...

    Unlocking Using the Inner Handle of Front Doors
    Pull the front door inner handle. The door unlocks and opens in one motion. The inner front door handles are designed to allow front seat occupants to open the door in one motion. However thi ...

    Resetting the Engine Oil Life Display
    Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition sw ...