Rear License Plate Light Bulb

When replacing, use the following bulb.

Rear License Plate Light: 5 W

Models with trunk lid lining

1. Remove the screw from the center of the


1. Remove the screw from the center of the fastener using a Phillips-head screwdriver.

2. Remove the holding clips using a flat-tip screwdriver, then pull the lining back.

All models

3. Remove the license plate light assembly by


3. Remove the license plate light assembly by squeezing the tabs on both sides of the socket.

4. Remove the old bulb and insert a new bulb.

    See also:

    Braking System
    Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The emergency brake assist system increases the stopping force ...

    Important Safety Precautions
    You’ll find many safety recommendations throughout this section, and throughout this manual. The recommendations on this page are the ones we consider to be the most important. Always Wear ...

    Fuses
    The vehicle’s fuses are contained in three fuse boxes. The driver’s side interior fuse box is under the dashboard on the driver’s side. The fuse label is attached to the side panel. ...