How to Set Up the Jack

1. Place the jack under the jacking point


1. Place the jack under the jacking point closest to the tire to be changed.

2. Turn the end bracket (as shown in the


2. Turn the end bracket (as shown in the image) clockwise until the top of the jack contacts the jacking point.

Make sure that the jacking point tab is resting in the jack notch.

3. Raise the vehicle, using the jack handle bar


3. Raise the vehicle, using the jack handle bar and the jack handle, until the tire is off the ground.

The vehicle can easily roll off the jack,


The vehicle can easily roll off the jack, seriously injuring anyone underneath.

Follow the directions for changing a tire exactly, and never get under the vehicle when it is supported only by the jack.

Do not use the jack with people or luggage in the vehicle.

Use the jack provided in your vehicle.

Other jacks may not support the weight ("load") or their shape may not match.

The following instructions must be followed to use the jack safely.

• Do not use while the engine is running.

• Use only where the ground is firm and level.

• Use only at the jacking points.

• Do not get in the vehicle while using the jack.

• Do not put anything on top of or underneath the jack.

    See also:

    Safety of Infants and Small Children
    ■Protecting Infants An infant must be properly restrained in a rear-facing, reclining child seat until the infant reaches the seat maker's weight or height limit for the seat, and the inf ...

    Accessory Power Sockets
    Your vehicle has two accessory power sockets; one is at the front of the center console and the other is in the console compartment. To use an accessory power socket, the ignition switch mu ...

    Wipers and Washers
    The windshield wipers and washers can be used when the ignition switch is in ON . ■ MIST The wipers run at high speed until you release the lever. ■ Wiper switch (OFF, INT, LO, H ...