Inspecting and Changing Fuses

1. Turn the ignition switch to LOCK


1. Turn the ignition switch to LOCK headlights and all accessories off.. Turn
headlights and all accessories off.

2. Remove the fuse box cover.

3. Check the large fuse in the engine compartment.

If the fuse is blown, use a Phillips-head screwdriver to remove the screw and replace it with a new one.

4. Inspect the small fuses in the engine


4. Inspect the small fuses in the engine compartment and the vehicle interior.

If there is a burned out fuse, remove it with the fuse puller and replace it with a new one.

NOTICE


Replacing a fuse with one that has a higher rating greatly increases the chances of damaging the electrical system.

Replace fuse with a spare fuse of the same specified amperage.

Confirm the specified amperage using the charts.

There is a fuse puller on the back of the engine compartment fuse box cover.

    See also:

    USB Flash Memory Device Error Messages
    If you see an error message on the audio display while playing a USB flash memory device, find the solution in the chart to the right. If you cannot clear the error message, take your vehicl ...

    Wiper Blades
    Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped ...

    Refueling
    1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th ...