Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:

1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode.

2. Select the zone indicator by


2. Select the zone indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.

3. Find the zone for your area on the zone map. Each zone number (1 through 15) corresponds to a compass zone.

4. Turn the select/reset knob to select the appropriate zone number, and press the select/ reset knob to enter the number.

When the system does not accept the selected compass zone, you see ‘‘- -’’ in the direction display. Select appropriate zone number again.

Security System


    See also:

    Load Limits
    Total Trailer Weight: The maximum allowable weight of the trailer and everything in or on it must not exceed 1,500 lbs (680 kg). Towing a load that is too heavy can seriously affect your ve ...

    Moonroof
    If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the ...

    Cruise Control
    Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is ...