Auto Door Unlocking

The auto door unlocking feature has five possible settings:

The auto door unlocking is deactivated all the time.

On A/T vehicles,

the driver’s door unlocks when you move the shift lever to the Park (P) position with the brake pedal depressed.

This is the default setting.

Both doors unlock when you move the shift lever to the Park (P) position with the brake pedal depressed (A/T vehicles).

The driver’s door unlocks whenever you turn the ignition switch to the ACCESSORY (I) position.

This is the default setting on M/T vehicles.

Both doors unlock whenever you turn the ignition switch to the ACCESSORY (I) position.

To turn off the Auto Door Unlock modes:

1. Make sure the shift lever is in the


1.

Make sure the shift lever is in the Park (P) position (A/T vehicles).

2. Turn the ignition switch to the ON (II) position, and open the driver’s door.

3. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click, and after about 5 seconds, you will hear another click.

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Park Unlock mode:

Unlocks the driver’s door or both doors when the shift lever is moved into the Park (P) position with the brake pedal depressed (A/T vehicles only).

1. Make sure the shift lever is in the


1. Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click.

Continue to hold the switch:

Until you hear another click (after about 5 seconds) to activate driver’s door unlock feature.

Or, until you hear two more clicks (after about 10 seconds) to activate both doors unlock feature.

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Ignition Switch Unlock mode:

Unlocks the driver’s door or both doors when the ignition switch is moved out of the ON (II) position.

1. Make sure the shift lever is in the


1. Make sure the shift lever is in the Park (P) position (A/T vehicles).

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. On A/T vehicles,

push and hold the brake pedal, then move the shift lever out of the Park (P) position.

4. Push and hold the rear of the master door lock switch on the driver’s door. You will hear a click.

Continue to hold the switch:

Until you hear another click (after about 5 seconds) to activate driver’s door unlock feature.

Or, until you hear two more clicks (after about 10 seconds) to activate both doors unlock feature

5. Release the switch, and within 20 seconds, turn the ignition switch to the ACCESSORY (I) position.

On A/T vehicles,

move the shift lever to the Park (P) position.

6. Turn the ignition switch to the LOCK (0) position.

Even if your vehicle’s battery is removed or goes dead, the system keeps the auto door lock/unlock setting which you selected.

    See also:

    iPod Error Messages (Models with navigation system)
    If you see an error message in the center display while playing an iPod, find the solution in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. ...

    Headlight Aiming
    The headlights were properly aimed when your vehicle was new. If you regularly carry heavy items in the trunk or pull a trailer, readjustment may be required. Adjustments should be done by y ...

    Resetting the Engine Oil Life Display
    Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition sw ...