Replacing Rear Bulbs

1. Open the trunk.


1. Open the trunk.

Remove the screws in the center of each of the two fasteners on the side of the trunk lining. Pull the lining back.

2. Determine which of the three bulbs is burned out: stop/taillight, back-up light or turn signal light.

3. Remove the socket by turning it


3. Remove the socket by turning it one-quarter turn counterclockwise.

4. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

5. Insert the socket back into the light assembly. Turn it clockwise to lock it in place.

6. Turn on the lights to make sure the new bulb is working.

7. Push the trunk lid trim back into position.

8. Put the fasteners into the holes on the side of the trunk lining.

Reinstall the screws.

    See also:

    Audio System Basic Operation
    Models with information display To use the audio system function, the ignition switch must be in ACCESSORY or ON . Use the selector knob or SETUP button to access some audio functions. Pre ...

    Fuel Recommendation
    Your vehicle is designed to operate on unleaded gasoline with a pump octane number of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic rapping noise that c ...

    What to Do After the Engine Starts
    Once your vehicle's engine has started, remove the jumper cables in the following order. 1. Disconnect the jumper cable from your vehicle's ground. 2. Disconnect the other end of the jumper cabl ...