Wipers and Washers

The windshield wipers and washers can be used when the ignition switch is in ON .


■ MIST


■ MIST

The wipers run at high speed until you release the lever.

■ Wiper switch (OFF, INT, LO, HI)

Change the wiper switch setting according to the amount of rain.

■ Adjusting the delay

Turn the adjustment ring to adjust the wiper delay.

■ Washer


■ Washer

Sprays while you pull the lever toward you.

When you release the lever, the wipers make two or three more sweeps before stopping.

NOTICE

Do not use the wipers when the windshield is dry.

The windshield will get scratched, or the rubber blades will get damaged.

NOTICE

In cold weather, the blades may freeze to the windshield, becoming stuck.

Operating the wipers in this condition may damage the wipers. Use the defroster to warm the windshield, then turn the wipers on.

If the vehicle speeds up while the wipers are operating intermittently, the length of the wipe interval shortens. When the vehicle starts moving, the wipers make a single sweep.

When the vehicle speeds up, the wiper operation’s shortest delay setting (the LO setting become) and
the LO setting become the same.

Turn the washers off if no washer fluid comes out.

The pump may get damaged.

    See also:

    Advanced Airbags
    Your front airbags have advanced features to reduce the likelihood of airbag related injuries to smaller occupants. The driver's advanced front airbag system includes a seat position sensor. ...

    Seat Belt Inspection
    Regularly check the condition of your seat belts as follows: • Pull each belt out fully, and look for frays, cuts, burns, and wear. • Check that the latches work smoothly and the belts retract e ...

    Larger Outside, Larger Inside
    The Fit has grown by 4.2 inches in length and a half inch in width, but the greater change is in the cabin, which is almost 5 inches longer overall. If you're familiar with the 2008 Fit, know that ...